Enamo Grip SAS is a two-part aliphatic polyurethane enamel, based on the same chemistry as the base formula of Enamo Grip, yet designed using a proprietary system to give the slick surface for resisting attachment of damp chemical compounds inside industrial tubes or resisting barnacle and algae attachment on boat hulls. Enamo Grip SAS will self-level to an even and smooth finish. It is tough enough to withstand the abrasion of wind or water movements.


  • More information coming soon.


Product Chemistry Urethane based
Volume Solids 38%
VOC Level 4.1 lbs/gal
Dry Time 30-60 minutes to tack free at 70°F
Cures By Chemical reaction

Typical Uses

1. For architectural and maintenance solutions that require the utmost in exterior durability and low dirt retention;
2. As a topcoat for Rust Grip® and Moist Metal Grip; *For anti-graffiti protection;
3. Inside exit tubes in industrial plants to resist accumulation or build-up;
4. Exterior of boat hulls to resist barnacle and algae attachment; *When a slick finish is needed, but toughness is required. *ABS tested and approved for marine use, to block barnacles, seaweed, and algae attachment.

Application Methods

Enamo Grip SAS can be applied to metal, concrete, masonry, wood and other porous surfaces. The application can be by brush, roller, or airless sprayer. For specific instructions on surface preparation, mixing and application, please refer to the SPI’s application instructions for Enamo Grip SAS.

Resources & Downloads

Product Information