Super Therm® Texture
Super Therm® can be applied by brush, roller or spray, however, the preferred method is by airless sprayer. It should never be applied directly over rust, nor should it ever be diluted or thinned.
The finished is a ceramic, silky matt textured coating that contains 57% solids by volume. If visual appearance is important and in public view, the coating does mark easily. We recommend an application of an epoxy or our Enamo Grip to create a shiny finish and added protection and durability to your project.
Like any project, preparation is key. Corrosion can be a big issue if not treated prior to any application. Although Super Therm® does have a moisture barrier when applied to the correct thickness of 425 microns wet/250 microns dry, if the corrosion is not treated prior it will be drawn through the coating as Super Therm® is a water-based product.
Pressure clean the substrate, treat the corrosion of flash rust prior to application of Super Therm® with Rust Grip® or another corrosion converter.
Texture of Super Therm® on a corrugated roof by airless sprayer.
Super Therm® applied to a bus by roller to stop the heat.
Texture of Super Therm® close up by airless sprayer.
Super Therm® with texture applied by airless on a galvanised roof. Tinted slight yellow.
Flash rust appearing on a shipping container after Super Therm® was applied but not treated prior.
Super Therm® applied too thin on side of a container by airless. No moisture barrier is created allowing flash rust to appear.
Super Therm® applied by airless to a corrugated roof.
Super Therm® applied by brush and while wet back rolled with a nap roller.
Super Therm® applied too thick by brush. The coating will dry with streaks. Correct thickness is 425 microns wet (.425mm) and back roll with nap roller for cleaner texture.
Super Therm applied to a truck to block the sun's heat and reduce the noise insulation coating
Super Therm applied to a truck to block the sun's heat and reduce the noise insulation coating
Super Therm® applied too thick by brush. The coating will dry with streaks. Correct thickness is 425 microns wet (.425mm) and back roll with nap roller for cleaner texture.
